Be the first to review “3M 60921
ORGANIC VAPOR CARTRIDGE/FILTER, P100” Cancel reply
ORGANIC VAPOR CARTRIDGE/FILTER, P100” Cancel reply
The 3M™ Organic Vapour Cartridge/Filter 60921 is NIOSH approved against certain organic vapours and particulates. Use with 3M™ Half and Full Facepiece, 6000, 3M™ Half and Full Facepiece, 7000, and 3M™ Half and Full Facepiece, FF-400 Series with bayonet filter holders.
3M™ Organic Vapour Cartridge/Filter 60921 P100 helps provide protection against certain organic vapours and particulates in a variety of environments. The cartridge/filter combination may be used for respiratory protection from certain organic vapours and non-oil and oil particulate concentrations up to 10 times the Permissible Exposure Limit (PEL) with half facepieces or 50 times PEL with quantitatively fit tested full facepieces. This cartridge/filter is not for use in environments that are Immediately Dangerous to Life or Health (IDLH). Recommended applications for the cartridge/filter include chemical clean-up, chemical compounding, chemical transfer, laboratories, and pesticide application. Inventory needs and training requirements for safety equipment are reduced because this respirator cartridge selection works for many different applications. This cartridge/filter is commonly used in the following industries: agriculture, chemicals, mining, oil and gas, pharmaceuticals, and primary metals.
$36.75
Out of stock
Buffing foam pads with a center ring back and hex face pattern to help dissipate polish or compounds evenly, minimizing grabbing and reducing heat.
3M™ Soft Edge Foam Masking Tape provides a fast and easy way to mask door jambs and other apertures, such as hood and deck lid openings.
Limco LC4200 Low VOC Clearcoat is a low 250 gms/liter VOC acrylic urethane clearcoat for use over Limco Supreme PLUS low VOC basecoat colors. LC4200 is easy to apply and has excellent gloss and leveling.
High performance strip abrasive for coarse, medium and fine sanding of polyester putty filler and paint materials. It has a dust repellent coating.
High performance abrasive for machine sanding surfaces. Stands out because of its good initial abrasiveness, its high durability and the very fine finish in higher grits.
Roll : 70 mm x 50 m
Paintable in 30 minutes. Permanently flexible with no shrinkage. Withstands salt water and most solvents
Reviews
There are no reviews yet.