your trusted source for automotive paint and refinishing
Shopping Cart$157.25
1
PROUDLY CANADIAN
FREE GROUND SHIPPING ON ORDERS OVER $450
View cart “3M 16325 PPS Kit, Large 125U, Full Diameter” has been added to your cart.
Sale!
NORTON 31624 P400B A275 Magnum Sheets (9X11 Sheet)
For dry sanding old paint, primer, primer surfacer, and between-color coats; also for deburring, removing sand scratches, shaping and finishing plastic filler, and featheredging repaired areas. Special No-Fil coating prevents premature loading. Can be cut into halves or thirds to fit neatly on jitterbug sanders.
Champagne Magnum is sand paper technology at it’s best. It cuts faster, runs cooler, resists loading better and lasts far longer than any conventional sandpaper.
Premium heat-treated grain extends life and gives a 30 – 50% faster cut rate
Premium B-Weight latex paper backing improves performance, is more flexible and easier disc removal
FEPA P-graded grain achieves a more consistent uniform scratch pattern
Re-designed bond system optimizes grain adhesion and extends cut life
Newest water based stearate No-Fil improves load resistance
No pigment in No-Fil or bond eliminates the risk of color transfer and creates a much stronger bond
Norton 6728, 16′ x 400′ Plastic Overspray Sheeting is an economical way to protect surfaces not being painted. The Norton 6728 is a thin mil plastic sheeting that is fast and easy to handle and apply. It will cling to surfaces being masked and resists tearing when pulling or repositioning. Since it is Corona treated paint will adhere without flaking off, while resisting solvent pentration and paint bleed through.
The 3M™ Particulate Filter 2071 is NIOSH approved for environments containing certain oil and non-oil based particles.
Use with 3M™ Respirators, 5000 Series or 3M™ Cartridge, 6000 Series with 3M™ Adapter, 502, or 3M™ Half and Full Facepiece, 6000, 3M™ Half and Full Facepiece, 7000, and 3M™ Half and Full Facepiece, FF-400 Series with bayonet filter holders. When properly fitted, use in a variety of applications such as grinding, sanding and welding for concentrations up to 10 times the Permissible Exposure Limit (PEL) with half facepieces or 50 times PEL with full facepieces. Full facepieces must be quantitatively fit tested to claim assigned protection factor above 10 in negative pressure mode. The filter is both flame and water resistant. Do not use in environments that are immediately dangerous to life or health (IDLH). 3M offers a wide array of options when it comes to cartridges and filters. 3M™ Respirator Cartridges and Filters offer easy installation to your Powered Air Purifying Respirators (PAPR) or Supplied Air Respirator assembly making them a great choice for fast paced industrial environments.
NIOSH approved for environments containing certain oil and non-oil-based particles
Bayonet compatibility allows use with many 3M™ Half and Full Facepiece Designs
Bayonet compatibility allows use with many 3M™ Half and Full Facepiece designs
Advanced Electret Media (AEM) provides lightweight, easy breathing comfort
Two-part epoxy (1:1) used to repair most plastic parts, including bumper covers and other plastic body panels including PP, fiberglass, Metton, Telene, SMC, TEO and urethane. Formulated to finish the front side of flexible repairs or used over the top of urethane adhesives. Incredibly easy to sand in 20 minutes or less. No plastic identification required. No adhesion promoter needed No tip needed-hand mix with a clean spreader. Work time: 1-2 mins Sanding Time: 15-20 mins Paint/Cure time: 60 mins.
Abrasives
